10 mhz problem ...while running tx gain

[Bob McGraw - K4TAX]

What is the length of the coax jumper between the radio and dummy
load?    Also, if an antenna analyzer is available, run a sweep on the
load, with the meter in place  and observe the results.

73

Bob, K4TAX


Message: 11
Date: Thu, 28 Jan 2021 10:50:35 -0500
From: Bill Steffey NY9H<[hidden email]>
To: Elecraft List<[hidden email]>
Subject: [Elecraft] 10 mhz problem ...while running tx gain
Message-ID:<[hidden email]>
Content-Type: text/plain; charset=utf-8; format=flowed

i am very rarely on 10 mHz,


while running tx gain set , the calibration fails at 10mhz due to

  ? SWR 3.3-1 TOO HIGH FOR CALIBRATION.


checking other bands..160- 6 all read low swr


lp-100 & WATERS swr/load? read low swr ..... ? hi swr? just reads on
radio & faults the tx gain procedure ????


ideas ???


--
This email has been checked for viruses by AVG.
https://www.avg.com


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]