100w amp plate

[Mike Kasrich]

Has anyone else received an amp plate that was cut backwards?  The pixs
show the plate with fans attached with the lead fed through the upper
right.  I cant orient the slots with the finished side out  with the
plate that came with the kit. in that direction.

Just curious.  Up until this point the build and Calibration was going
smooth now Im at a stand still.

Mike/aj9c

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Ken Wagner K3IU]

Hi again, Mike:

I didn't notice that there was a finished side and an unfinished side on
the fan panel if that is what you mean by "Amp Plate." Both sides were
about the same as I recall. Can you install it per the manual with what
you call the "finished side" perhaps facing a direction other than what
you tried??? If so, then you can press on with the installation and if
you have defective paint on the fan panel, I'm sure that Elecraft will
send you a replacement.

73,
Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Mike Kasrich wrote:
> Has anyone else received an amp plate that was cut backwards?  The
> pixs show the plate with fans attached with the lead fed through the
> upper right.  I cant orient the slots with the finished side out  with
> the plate that came with the kit. in that direction.
>
> Just curious.  Up until this point the build and Calibration was going
> smooth now Im at a stand still.
>
> Mike/aj9c
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com