I have been enjoying my newly built K2 #058xx for several weeks now. I
have seen the posts about excessive current draw on 160, but many of
them are involving the 100w amp, which I do not have (yet). Well, I
have the same problem, draw sometimes exceeds 4 amps on 160. Power
supply is stable 13.8v. I saw an old post suggesting bypassing the
ISENSE line on the control board with a .01 to .1 cap, soldering it
across R7. Having a very new edition K2, I decided to check the
schematic and found that a cap, listed as C44, is shown in parallel with
R7, but it says "not used". So, before trying this fix, I figured I
would put it on here and see what the gang knows about this issue.
Thanks in advance for any input
73, Paul, N2PD
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Paul, N2PD
Locked
