A relatively quick fix...
I looked with my 'scope and saw the oscillator peter
out with the dial set to around 1925 ... a couple
counterclockwise turns of L30 snapped it right into
place.
No issues on any other bands.
Took the opportunity while the rig was open to re-cal
the PLL, re-set some filters, tighten the PA screws on
the KPA100.
I used the 10 MHz oven output (from a frequncy counter
from work) to snug up the internal counter. Rig is on
frequency, every frequency.
Incedentally, it puts out around 140W on 160,
according to the LP100.
Thanks for the assist.
Steve KZ1X/4
____________________________________________________________________________________
Now that's room service! Choose from over 150,000 hotels
in 45,000 destinations on Yahoo! Travel to find your fit.
http://farechase.yahoo.com/promo-generic-14795097_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
