Don,
Those diodes sit (electrically) right near the antenna jack, and are
thus exposed to strong static and lightning surges. If you operate
when lightning is in the vicinity, they may become damaged.
Of course, if you do not disconnect your antennas when not in use, you
are almost certainly assured that sometime during the spring and summer
seasons those diodes will be damaged. Also be aware that rain and snow
induced static can pack quite a charge too, so it is best to disconnect
the antennas when not in use no matter what the season - it protects not
only your K2/100, but also you, your home and your family.
If you do not wish to give care to the diodes, you could replace them
with 1N4148 diodes which are a bit 'tougher' than the 1N5711s, but you
will sacrifice some power control accuracy at low power and the 1N4148s
are not as flat with respect to frequency as the 1N5711s so you might
experience some bands where the indicated power and the actual power
differ more than with the 1N5711s.
73,
Don W3FPR
[hidden email] wrote:
> I have just recently re-subscribed to the reflector. So I have no knowledge
> of what may have been said regarding the two reference diodes, D 16,D17 in
> the K2/100 and D1,D2 in the KAT100.
> After building and using my basic K2 back in 2000, I decided to upgrade to
> the K2/100 and the KAT100.
> I finished both of them about three weeks ago and was enjoying the two
> units.
> In the last two weeks though I have blown these diodes twice. Is this an
> isolated incident?
> Don...KA7L
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
