Hi Everybody!
I'm in the process of building a widget to work with my K2 and future K3.
I am using the nifty little 2D connectors to tye the case and PCB
together like in the K2 and was wondering about the dimensions of this
thing.
It's made out of 1/4" Sq. bar stock and 1/2" wide. The screw thread is
for 4-40 fasteners. The one hole is centered on one side 1/8" by 1/4" and
the other two holes are offset from their edge by .15" but spaced 7.5mm
apart. Why mix inches with mm? I have no problem with it's application
but...
I'm really curious.
Best regards, Bob K7HBG
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
