30 meters again

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

30 meters again

srife
        Don W3FPR, I wanted to relate something I am seeing with the K2
S-meter when tuned to the 30m band. I have two bars showing continuously,
whether I have the preamp off or the attenuator on or the antenna completely
disconnected. Just shows those first two bars all the time. It does not do
this on any other band. I tried power cycling the K2 and this did not help.
Do you have any idea what might be causing it?

Stan Rife
W5EWA
Houston, TX
K2 S/N 4216
 

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply | Threaded
Open this post in threaded view
|

RE: 30 meters again

Don Wilhelm-3
Stan,

That is quite unusual to have the S-meter at an S-3 level with no antenna on
only one band - that would be an indicator of some internal signal being
picked up inside the receiver.  That is not typical, so you do have
something abnormal there.

One potential source is 2nd harmonic radiation from the 5.068 mHz oscillator
in the AGC IF (on the control board) and is being picked up by the receiver
front end, but that is only a guess - you may want to examine that area to
see if it is well soldered and try to clip any leads that may be acting as a
short antenna.  I have never observed a similar condition on any K2, so it
is not characteristic of the receiver design.

OTOH, if you really have a strong signal source at your location, it could
be picked up even with no antenna connected.  Try shorting the antenna and
see if that lowers the level - if it does, look for your local source of
radiation.  Try another receiver to see if it also picks up 'bad stuff' in
the 30 meter vicinity.

73,
Don W3FPR

> -----Original Message-----
>
> Don W3FPR, I wanted to relate something I am seeing with the K2
> S-meter when tuned to the 30m band. I have two bars showing continuously,
> whether I have the preamp off or the attenuator on or the antenna
> completely
> disconnected. Just shows those first two bars all the time. It does not do
> this on any other band. I tried power cycling the K2 and this did
> not help.
> Do you have any idea what might be causing it?
>
> Stan Rife
> W5EWA
> Houston, TX
> K2 S/N 4216
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.15.15/580 - Release Date: 12/8/2006
12:53 PM

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com