4.21 APF impressions

classic Classic list List threaded Threaded
3 messages Options
Reply | Threaded
Open this post in threaded view
|

4.21 APF impressions

Howard..K2HK

Been playing with the new 4.21 release for a few hours. My impressions of the APC  is it is an excellent addition to the CW op's tools. Smoothly boosts the weak signal out of the noise. Thanks to both Elecraft and the reflector members who pushed for this refinement. Although we might get tired of seeing similar posts urging a wanted addition it sure is beneficial when the results are like this one.

The only change I note on SSB is that I can turn my gain down to 5~6 with a Yamaha CM500(?) It was previously at ~19. One other note I can't hear any difference if I am using High or Low bias. Checked with monitor and DVR.

73,
Howard..K2HK




     
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: 4.21 APF impressions

David Pratt
Has it now been released, Howard?  I've just been trawling all the FTP
folders without success.  Please advise.

David G4DMP

In a recent message, Howard K2HK <[hidden email]> writes
>Been playing with the new 4.21 release for a few hours.



______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: 4.21 APF impressions

Don Wilhelm-4
In reply to this post by Howard..K2HK
  Howard,

One correction - the High or Low do not apply to the bias.
The thing that High and Low refer to is the range for the mic level.
You should see a change in the audio (ALC) level when switching between
High and Low, but since your mic level is now set to a low value, there
may only be a slight difference.

73,
Don W3FPR

On 11/13/2010 1:36 PM, Howard K2HK wrote:
> The only change I note on SSB is that I can turn my gain down to 5~6 with a Yamaha CM500(?) It was previously at ~19. One other note I can't hear any difference if I am using High or Low bias. Checked with monitor and DVR.
>
> 73,
> Howard..K2HK
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html