If that's a real problem, install 5.10, do the
calibration then move on to 5.14. You only need
to do the 50 W cal once, they say.
Phil W7OX
On 3/6/15 9:56 PM, Dave Anderson, K4SV via
Elecraft wrote:
> Hi All,
> I just installed the 5.14 in my K3 and when I ran the 5 and 50 watt TX calibration I kept getting "Calibration power settled at " 3.495.72;" and it would abort.
> It appears that during this calibration procedure VFO B is being used. When it got to 80 meters it would abort. My VFO B was set to 3495.72, which is out of band and being out of band I do not think the transmitter will transmit RF power. This caused the abort.
> Perhaps the Calibration software should set the VFOs in band before preforming the calibration.
> Once the VFO was set in band all is well.
> Best 73 Dave Anderson, K4SVTryon, NC 828 777-5088 WWW.K4SV.NET
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
