It's in the firmware release notes.
MCU 4.31 / DSP 2.72, 3-23-2011
< other text removed >
Remote-Control/Switch Macro Command Changes:
* "AP" COMMAND TURNS APF ON/OFF: You can turn the CW audio peaking filter
on/off by sending "AP1;" or "AP0;", respectively.
Applies only in CW mode with CONFIG:DUAL PB set to APF. (Not yet available
for direct sub receiver control. Swap VFOs or do A>B copy in order to set up
sub receiver APF.) You can use this command to create a TAP function to turn
APF on/off; use the Help function in K3 Utility for details on macros.
Dick, K6KR
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]] On Behalf Of Georges Ringotte
F6DFZ
Sent: Wednesday, October 19, 2011 11:05 PM
To:
[hidden email]
Subject: [Elecraft] AF peak filter
Hi to the group,
Is it possible to write a macro command switching on or off the AF peak
filter ?
I do not see anything in the programmer reference document.
Best regards
Georges
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html