Scanning through the manual I saw that the ALC voltage to be applied on pin
15
of the ACC connector needs to be in the 0 - +5V range. This worries me a
bit because
many (if not virtually all) linear amps output a NEGATIVE ALC voltage for
feedback
to the transceiver.
I currently use my FT1kMP in combination with a SPE 1K-FA solid-state amp,
fully interfaced including ALC and that is working very well. The SPE
outputs between
0 and -11V, such that the right output is generated.
Is the +5V maybe a typo (i.e. should it be -5V) ??
-- Enno, PF5X
--------------------------------------------------------------------
mail2web.com - Microsoft® Exchange solutions from a leading provider -
http://link.mail2web.com/Business/Exchange_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
