Hallo Vic,
Many thanks for the info. I thnink I am dealing with issue number 2).
By now I am quite shure that the driver part of KPA100 option is
draining power on 20/30m avoiding the last stage to reach full
Power.
I am going to ask Gary.
Regards
Martin
-----Ursprüngliche Nachricht-----
Von: Vic Rosenthal [mailto:
[hidden email]]
Gesendet: Montag, 6. Juni 2005 13:49
An: Renardy, Martin {GY-E~Mannheim}
Cc:
[hidden email]
Betreff: Re: [Elecraft] Low power on 20m using the KPA100 option
Renardy, Martin wrote:
> last weekend I finished the KPA100 option, which is causing a little
> problem. Everything Is running well except power on 20m, where I just
> reach 50 Watts.
>
> The QRP output is not affected, so I am quite shure that the RF path
> to the antenna through the LPF is ok. Just to be shure I have checked
> all inductivities and capacities
> of the 20m filter. They are ok including the used core types of the
> inductivities.
If you are getting 10 watts output when you set the power control to 10
watts, check the current draw at this power level by tapping Display.
You should be drawing less than 3 amperes in this condition. Check also
at 11 watts, with the KPA100 on. It shouldn't be much higher. If it
is, you may have problem (2) below.
I found two problems in my K2/100 which caused slightly (in my case)
reduced output on 20 meters:
1) the bandpass filter tuning trimmers were both at maximum capacity.
Adding a few pf in parallel with them allowed the QRP portion of the K2
to develop more drive for the KPA100 with less current draw.
2) There is a known issue with some new KPA100s that the amplifier
requires abnormally high drive on 20 and sometimes 30 meters. This
causes high current draw in the low-power stage and inability to reach
full output. Gary at Elecraft was helpful to me about this
<
[hidden email]>.
--
73
Vic, K2VCO
Fresno, CA
http://www.qsl.net/k2vco_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
