This was covered in a post on the reflector a couple days ago - a small
padder capacitor from the junction of X3, X4 and C174 to ground may solve
your BFO low frequency problem. Use 1 or 2 pf and recheck both ends of the
BFO range after adding it.
Normally 4912.86 can be low enough except in extreme cases - note that the
LSB BFO is set at 4913.7 which is well within your currently available BFO
range.
73,
Don W3FPR
> -----Original Message-----
> From:
[hidden email]
> [mailto:
[hidden email]]On Behalf Of
[hidden email]
> Sent: Monday, July 03, 2006 1:30 PM
> To:
[hidden email]
> Subject: [Elecraft] Additional Info on Problem
>
>
> On double checking the BFO Test (pg 62 of manual) the BFO Low
> Freq. is too
> high. The manual says it should be less than 4912.7 mine is
> 4912.86. How can I
> lower it?
> _______________________________________________
> Elecraft mailing list
> Post to:
[hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>
http://mailman.qth.net/mailman/listinfo/elecraft> Mime-Version: 1.0
> Content-Transfer-Encoding: 7bit
> Content-Type: text/plain; charset=US-ASCII
>
> Help:
http://mailman.qth.net/subscribers.htm> Elecraft web page:
http://www.elecraft.com>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.394 / Virus Database: 268.9.8/380 - Release Date: 6/30/2006
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
