Alignment and test, part III

[Yves Dussault]

 Well, K2 4875 is coming...

BUT:
-On page 74...Why connect a key? Later in the instructions we do not use it,
right?
-On page 75, L1 and L2 have no effect on power when I hold TUNE which shows
0.4....and stays there...
-I did the receiver pre-alignment on page 76 (using an external transmitter
as a signal source) and all went fine.

Suggestions where I should start looking?
 
 

Yves Dussault-VE2ATD
Laval, Québec.
450 661-0768_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Rolf Moberg, OH6KXL]

Yves Dussault wrote:

> -On page 75, L1 and L2 have no effect on power when I hold TUNE which shows
> 0.4....and stays there...

Pretty similar to my problem. My solution was to install C167 which I
had forgotten to install earlier. page 50

Rolf Moberg
oh6kxl
#4759
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com