It sounds like you may have a spurious oscillation problem inside the box. A
spur can drain a high level of power, be off frequency, destroy finals, etc.
The power on one band and none on the other sounds like you may have a
component misplaced or wrong value - including the tuning of the coil. Another
possibility is a bad solder joint so a critical capacitor value is not being
seen. I suggest doing a real thorough visual on both sides of the board and
maybe a touch up on all the solder joints on those bands.
Al WA6VNN
In a message dated 6/27/2008 12:27:19 A.M. Pacific Daylight Time,
[hidden email] writes:
I lied about lying about the power, after realigning my filters my 12 and
10m power is normal. The signal is still horrible, however.
--
73 de n1ywb
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
**************Gas prices getting you down? Search AOL Autos for
fuel-efficient used cars. (
http://autos.aol.com/used?ncid=aolaut00050000000007)
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
