These messages don't indicate a failure.
The K3 Utility sent a command to the K3 to reset itself to enter the boot
loader. It's a progress status message, not an error message.
I considered wording the message to "Resetting K3 to enter boot loader", but
I think I'll just remove the message instead.
I apologize for any confusion.
Dick, K6KR
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]] On Behalf Of wa6riv
Sent: Wednesday, April 22, 2009 6:11 AM
To:
[hidden email]
Subject: [Elecraft] [K3] Boot loader failure (solution)
I had an update failure this morning.
"MCU firmware file hmcu0311.hex verified
Reset K3 to enter Boot Loader"
In the Elecraft K3 Utility, I tested communications. "4800 bps"
I selected default. "Keep speed at 38,400 bps"
Load error occurred.
I reset my communications to 4800 bps and all worked fine.
TNX Ted WP4CW
Window Vista
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
