Paul,
Build and test the KSB2 and the K60XV first - after those are installed, you
can do a complete alignment and calibration of the K2 and that alignment and
calibration will not be changed by the addition of the KDSP2 or the KPA100.
Those options which affect the base K2 alignment in some way (large or
small) are the KSB2 (filter alignment), K160RX (VCO and bandpass alignment),
and the K60XV (VCO and bandpass alignment). The other options may be
aligned independently and do not change the base K2 settings.
73,
Don W3FPR
> -----Original Message-----
>
> I am well underway, RF board part 2 has been tested and works
> fine. Lots of signals on 40 meter. I am mid way through part 3
> and have a question on the build order of the other options. I
> will assemble and test the K2 completly before continuing by
> adding options. I have the KSB2, K60XV, DSP and KPA100 to add.
> In what order should the options be installed and could some be
> combined ( like the DSPand the K60XV) to minimize assembly and
> disassembly. Would you leave the KPA100 to last?
>
> My skill level is moderately advanced (electrons in my blood/EE)
> plus a fair set of test equipment.
>
> 73 de Paul W4MAY
> K2 s/n 5627
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
