I have had the pleasure to build with Surface Mount integrated
circuits. It is critical to get them to stand up on the outline on the
printed wiring board, but then when you get the four corners right then
I just use a tiny amount of solder and get the 28 other pins soldered.
It is almost impossible to solder that many pins and not have a
short or 2 or 5 or... This used to be a problem but no more. Now I make
sure every pin is soldered and then with solder wick from Mouser I suck
all the excess solder from all 32 pins and look with care and NO shorts
are found!
So now I do not worry about a solder bridge. I just fix it after the
fact. I did this a while back on my T1 auto tuner and it worked just fine.
73 Karl K5DI
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
