Chris,
I would think the input levels of whatever instrumentation you will
connect to the coupler as well as the power levels that you will have at
the input will dictate whether you build it for -20 dB or -30 dB.
I have both and use them on the test bench with a Tandem Match power/SWR
meter. For better accuracy at lower powers, I use the -20 dB coupler
and my Tandem Match gives good results from about 2 mW up to 200 Watts.
If I have need to measure above 200 watts, I switch to the -30 dB
coupler which gives me a range from 20 mW to 2000 Watts.
My application is just one example - look at your highest power level
and the sensitivity of your instrumentation. That will tell you which
range you need.
73,
Don W3FPR
Chris Meagher wrote:
> I have a CP1 dual directional coupler kit.
> Debating whether to make it -20dB or -30dB.
> If I were to make it for -20dB, could I then add Elecraft step attenuator
> to extend the range without causing problems at higher wattage (like core
> saturation with the 20dB toroids).
> Thanks for any help.
> Chris VK2LCD K2#3666, K3#685
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.339 / Virus Database: 270.12.34/2122 - Release Date: 05/19/09 06:21:00
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
