CW Skimmer/Soundcard Connection

[pastormg]

Good Evening, I have just hooked up the Line Out on the back of the K3 to the Input of my Soundblaster USB Card. In the K3 Manual it talks about the Config. Line Out to set the level. What number should I be setting mine at? Also, I assume that if I use my filters that it will limit the number of signals that CW Skimmer will hear. Any help would be greatly apprreciated. Mark Griffin, KB3Z
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Arie Kleingeld PA3A-2]

Hi Mark,

Yes, if the skimmer is hooked up via audio, that's what will be decoded.
Line-out here is set to 10. Ok  in my case.

Experiment a bit withe the soundcard volume/level settings and it will
work for you.

73
Arie PA3A

[hidden email] schreef op 10-4-2014 1:15:
> Good Evening, I have just hooked up the Line Out on the back of the K3 to the Input of my Soundblaster USB Card. In the K3 Manual it talks about the Config. Line Out to set the level. What number should I be setting mine at? Also, I assume that if I use my filters that it will limit the number of signals that CW Skimmer will hear. Any help would be greatly apprreciated. Mark Griffin, KB3Z
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]