Hello everyone. I'm having a problem calibrating the dial on my K2. I followed the procedure by Wayne to set the master oscillator with C22 on the control board. I am able to use the signal at 10 MHz an get the readings to match up at TP1 and TP2. However when I run CAL PLL the dial is off by about .30 high. I noticed that when I hear the tone from WWV and touch the RF probe to TP3 the tone increases in frequency. After I let go of the probe the frequency remains higher. I think this is causing CAL PLL to come up with bad readings. I removed TP3 and just touched the solder pad but I still hear the increase in frequency as long as the RF probe is connected. Does anyone have an idea what might cause this problem? Thanks.
Harvey KN6VP
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.392 / Virus Database: 268.5.6/340 - Release Date: 5/15/2006
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
