Can't acess KDSP2 menus...

[Steve Kallal]

I'm looking at page 24 of the KDSP2 manual. In the "KDSP2 Primary Menu"
section it says:

----------------------------------------------------------------------------
----------------
In SSB or CW modes, the primary menu is used for the auto-notch and noise
reduction functions. In
RTTY, the primary menu is the Filters menu, described below.

>From the primary menu, you can toggle the noise reduction adaptive filter
(generally referred to as a "denoiser" and, in the SSB mode, the auto-notch
filter. You can also adjust the denoiser's level from 1 (least aggressive)
to 4 (most aggressive).

Let's assume you were in SSB mode using filter 2. Tap the DISPLAY button to
bring up the primary
menu in the K2 display:

S2 nr nt
----------------------------------------------------------------------------
----------------

At this point I don't get the results shown the manual. If I'm in the menu,
I toggle to between Pri and Sec. Otherwise I get the voltage and current
readings.

Is there something wrong with the manual? What am I doing wrong? Where is
the filters menu?

Help!!!

73,

Steve N6VL
K2 #2289

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Steve Kallal]

Jim,
 
I found the problem. I didn't have RTC turned on the Secondary menu. It
wasn't turned on with the KAF2, so I left it off. The KDSP2 requires it to
be turned for the DSP to work.

That said, please go ahead and send the logic diagram for the menus. I have
the Nifty for the K2, which goes into the KDSP2 in detail. Somehow I've
misplaced it.

Thanks,

73,

Steve N6VL
K2 #2289

________________________________

From: James Allen [mailto:[hidden email]]
Sent: Saturday, October 13, 2007 11:55 AM
To: [hidden email]; Steve Kallal
Subject: Re: [Elecraft] Can't acess KDSP2 menus...


Steve,
I will send you a logic diagram for the menus.
This should hopefully help.
 
Jim

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com