Capacitor Question

[Matt Palmer-4]

probably just a little paranoia on my part but:

on the K2 c133 is listed in the manual as a 104 (.1) and states to
bend it down, however the 104's are short and the pad is too large for
this cap, is this still the correct capacitor.

Thanks
Matt
KD8DAO
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-4]

Matt,

Yes, the pads are a bit wide for the cap, but you do have the correct
one.  Yes, be certain the top of it is below the 2D connector level by
bending it down or whatever other means you choose to employ.

73,
Don W3FPR

Matt Palmer wrote:
> probably just a little paranoia on my part but:
>
> on the K2 c133 is listed in the manual as a 104 (.1) and states to
> bend it down, however the 104's are short and the pad is too large for
> this cap, is this still the correct capacitor.
>
>  
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com