Command to read KAT3 settings

[Marian Morys]

Hi,

Is there a way to read  the L and C settings of the KAT3 after auto-tune cycle? Either computer command or control panel readout would work for me.

73,

Marian

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[wayne burdick]

Sure, Marian. Just set CONFIG:KAT3 to LCSET, then exit the menu. Next,
tap ATU TUNE. Instead of starting ATU tuning, this will display the L
and C settings (Ct/Ca configuration and C value on VFO A, L on VFO B).
In fact you can then tap ANT to change Ct/Ca, and rotate VFO A and B to
change C and L, respectively, if you want to manually adjust the match.

73,
Wayne
N6KR

On Feb 21, 2009, at 8:17 PM, Marian Morys wrote:

> Hi,
> Is there a way to read  the L and C settings of the KAT3 after
> auto-tune cycle? Either computer command or control panel readout
> would work for me.
> 73,
> Marian
>  

---

http://www.elecraft.com

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html