Control board resistance check problem

[Dr. Markus Dornach]

Hello friends,

i just finished soldering the control board. the resistance checks are ok with the following exceptions:

Test point:

Q1 collector  should be > 1 MegaOhm = i have only 203 k
Q2 collector should be > 1 M = i have only 200 k

U6 pin 29 should be 70-90 k = i have 24.9 k
U6 pin 30 should be 70-90 k = i have 26.3 k

all other checks are ok

any tipps? a short?

very 73 de Markus, DL9RCF

   
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com