I found, to do neat Bottom devices - I would pre-bend
device leads ahead of time. And I would then trim
devices leads, so that they extended just enough up
and above the PCB board's top surface before I
installed device. Then carefully hold the device
against the PCB board's bottom surface - and then
slightly and gently, bend each lead - in order to keep
device in place. Then sold from board's top!
After a while, I got pretty good at allowing very
short device leads, from poking thru on top!
Fred
FL
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
