Data modes

[Ross Biggar]

I have been playing with my new K3 (and enjoying it).
It looks like it will take over from my Orion II as my main tx.

A question.. Changing the data mode to AFSK A the bandwidth sets itself up for RTTY, as it is supposed to,
BUT when I go back to Data A the bandwith is still set up as for RTTY ie very narrow.
I have found the only way to set the bandwidth again to say 2.7khz is to readjust the width using "width and "lo"

Is this normal, or am I expecting too much for the K3 to go back to a normal bandwidth when changing data modes
from AFSK A to data A

Best wishes to all
Ross
ZL1WN
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Julian, G4ILO]

Ross-33 wrote

A question.. Changing the data mode to AFSK A the bandwidth sets itself up for RTTY, as it is supposed to,
BUT when I go back to Data A the bandwith is still set up as for RTTY ie very narrow.
I have found the only way to set the bandwidth again to say 2.7khz is to readjust the width using "width and "lo"

Is this normal, or am I expecting too much for the K3 to go back to a normal bandwidth when changing data modes
from AFSK A to data A

I think you are. AFSK A, DATA A, FSK D and PSK D are all the same mode really (they are reported as the same mode to logging software as well.) So it remembers just one filter selection.