I bought two factory K3S's, to save money one came without the
sub-receiver. I later realized that this was a mistake and added the
KRX3A. Installing it is a time consuming job and does involve removing the
front panel. I am not sure what your concern is, the front panel was easy
to reinstall and everything worked as it should after adding the module.
John KK9A
From: Irwin Darack idarack at gmail.com
Fri May 12 08:34:57 EDT 2017
different frequency on the same band) on my K3s, I need to install the KRX3A
sub-receiver. I have two K3s that I have built, one with the KRX3A and the
second without. I am thinking of upgrading the second one with the
sub-receiver now.
To install a KRX3A in an already built K3s do I need to remove the front
panel? I am hoping that I do not as to reinstall the front panel you have
to be very careful not to bend a pin. I realize that I have to install some
new additional stand-offs on the main RF board. I have reviewed the KRX3A
install instructions and it's a little confusing on the difference in a
older K3 versus a K3s. It appears that you have to take the front panel
totally apart?
Looking forward to see everyone at Dayton (Xenia).
Thanks, Irwin KD3TB
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
