What is the cure for an ERR BP2 in a K3? The manual says to de-install
KBPF3 on the RF board. This sounds serious and complicated.
Is this an error msg that must be fixed, or can it wait until our crew
returns from a dxpedition?
73, George
George Wagner, K5KG
Sarasota, FL
941-400-1960 cell
____________________________________
From:
[hidden email]
To:
[hidden email]
CC:
[hidden email],
[hidden email],
[hidden email],
[hidden email],
[hidden email],
[hidden email],
[hidden email],
[hidden email],
[hidden email]
Sent: 1/29/2012 4:31:44 P.M. Eastern Standard Time
Subj: RE: PJ4
Sunday afternoon update.
Got the 500hz filter installed and calibrated per the info from the
factory.
Installed the ext. RX board as well. All seems good at the moment.
Bob/George, still getting the ERR BP2 at initial power up though.
MD
-----Original Message-----
From: Bob Raymond, WA1Z [mailto:
[hidden email]]
Sent: Sunday, January 29, 2012 7:26 AM
To: <
[hidden email]>
Cc:
[hidden email];
[hidden email];
[hidden email];
[hidden email];
[hidden email];
[hidden email];
[hidden email];
[hidden email];
[hidden email]
Subject: Re: PJ4
Marty, what is the specific error code/message on the K3 display?
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
