Hello,
well, I spend all the night trying to fix this problem without luck.
What I did was to connect the SO2RXlat when the K3 was ON and connected to
the computer with the RS232 cable.
After that I have this ERR DSE, when I connect N1MM to control the radio and
I am in CW mode (no problem in SSB) Sometimes the K3 was without RX!!... I
turned it off, quit N1MM, turn K3 on and all was OK.
I disconnected the USB of the Piexx SO2RXlat, no luck
I installed twice the firmwares on the K3, no luck.
I installed again the N1MM full installer software and latest version, no
luck
I changed the COM port number, no luck
I connected another computer, no luck
So, no idea what happened when I installed this Piexx box!!!
Any help?
thanks,
Jorge
CX6VM/CW5W
De: Jorge Diez - CX6VM [mailto:
[hidden email]]
Enviado el: Domingo, 02 de Octubre de 2011 01:26 a.m.
Para: 'Elecraft Reflector'
Asunto: ERR DSE
Hello
I am trying to instal Piexx SO2RXlat for the DXDoubler to be connected to a
USB port.
Now I see this in my K3 display
E 0400C8
ERR DSE
>From the manual ERR DSE say reload DSP1 firmware
Really I need to do that? How?
I don´t know what´s bad when I wanted to install Piexx SO2RXlat
Any help?
thanks!
73,
Jorge
CX6VM/CW5W
K3 #4077
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
