Hi Jim, are you seeing these issues with the control cable between the
K3 and the KPA-1500 connected? Are you reading these output numbers on
the K3, the KPA-1500 or an independent power meter?
73, Pete N4ZR
Check out the Reverse Beacon Network
at <
http://reversebeacon.net>, now
spotting RTTY activity worldwide.
For spots, please use your favorite
"retail" DX cluster.
On 8/22/2020 11:16 AM, Jim McCook wrote:
> I have a spontaneous K3 failure after making no changes. This morning
> my K3 has only 1 or 2w power output when set to 100w or around 32w
> when the KPA1500 is turned on and set to OPER. It's the same on all
> bands and with a dummy load. It worked fine last night for several
> QSOs. I tried a 5w TX GAIN calibration but it failed with erratic,
> varying low power readings. I loaded a previous Configuration file
> but that didn't help. Whenever I press TUNE I get the ERR TXG message
> after shutting it off. Power in TUNE is set to 50w, but when I hold
> TUNE the display flickers between 2 and 8w. Any ideas? Jim W6YA
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
