ERR TXG when running 50 watt TX calibration procedure

[Alfred Frugoli]

Hello everyone again,

Thanks for the quick replies on the K3 Utility errors I was having last
night.  5W TX manual calibration worked just fine.

Now I've got my KPA3 installed, and when trying to run the manual 50 watt TX
calibration procedure, after going in to Tune mode (pressing and holding
XMIT/TUNE for 1 second), the display shows "- -" in VFO A and "0W" in VFO
B.  When I press XMIT/TUNE again to exit from Tune mode, VFO B reads ERR
TXG.  I have my FLTX set to FL1 ,which is the 2.7K filter, for all modes.  I
have run the Synthesizer calibration procedure already, as well as the
Reference Oscillator calibration using Method 2 (zero-beating).

Thoughts?

73 de Al, KE1FO

-----
Check out my Amateur Radio Contesting blog at ke1fo.wordpress.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html