Elecraft SSB Net - Monday evening

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

Elecraft SSB Net - Monday evening

Roger K7SJ
Greetings fellow Elecrafters and Elecrafters-to-be!

I will take another turn at the mic this evening on 40m.  Windy KM5Q will be
away this week.

The frequency: 7.190 +/-   The time: 6:00 PM PDT, 9:00 PM EDT.

Hope to hear you on the frequency!
73, Roger  WA7BOC
K3/100 #75
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
K3 #75
Reply | Threaded
Open this post in threaded view
|

re signal level of I F output on K3

Fern Rivard
    What is the level output of the I F output on the K3? I'm trying to use the Kenwood SM-220 panadaptor with mine but can't get enough output from the I F of the K3. I've got on loan an I F amp @ 8.215 mhz set at 15 db gain  from Jack of Clifton Laboratories to try and cure the problem but even with the amp I need a minimum of 200 microvolts signal input to the antenna jack of the K3 before I can even detect it on the SM-220 panadaptor  I F input even with the  15 db amplifier. Looking at the schematic of the K3, there should be approximately the same level coming out of the 8.215 khz I F as what the received signal is. The manual for the K3 does NOT give any information on this. Any help would be greatly appreciated.
    Thanks from Fern   VE7GZ



_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com