The router software should show if the K3 is connected. Make sure that
this works before opening the logging software. Like others have said, use
38400 baud. Carefully follow the MicroHAM instructions.
John KK9A
N6XI wrote:
You got good advice on baud rate. Also, it's wise always to confirm proper
operation with K3 Utility first. If it doesn't connect, chances are N1MM
won't, either. Utility marches through speeds until it finds one that
works. MM requires a specific speed setting.
73,
/Rick N6XI
Greg Best gbconsulting54 at gmail.com
Thu Feb 15 20:33:43 EST 2018
I am trying to get N1MM+ to talk to my K3 but will not do it.
I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1. DTR and DTS have
been tried with both Always ON and Always OFF but neither one works.
I have tried the Radio reset command from N1MM+ with no luck.
Can anyone help?
73¹s
Greg
16100 Outlook Avenue
Stilwell, KS 66085
816-792-2913
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
