I am confused - you have N1MM saying PSK, but you are trying to transmit
RTTY - the two do not mix.
Data A may be OK, but optimum for RTTY is AFSK A. The sideband is LSB
(DATA A is USB).
Since you have no problems with Fldigi alone, then the problem must be
with the introduction of N1MM.
You may find some clues on the N1MM forum.
73,
Don W3FPR
On 8/14/2015 10:04 PM,
[hidden email] wrote:
> Good Evening,
> This is Mark Griffin KB3Z. I was going to try and work some RTTY tonight using Fldigi and N1MM Plus. As most are aware of, you can access Fldigi from N1MM Plus. I am able to do this at least for receive. But when it comes to the transmit that is another issue. I have my K3 set to Data A. On my entry screen in N1MM it shows PSK. If I go to transmit, the K3 transmits, but I don't get any ALC Bars, plus it doesn't make the normal sounds that it should for Rtty during transmit. Now, if I get out of N1MM and just use FLDigi, there are no problems whatsoever. I am totally perplexed with this. Has anyone had any success in using Fldigi with N1MM plus and getting your K3 to transmit rtty the normal way? Any help would be much appreciated. If I can't get it to work I might try MMTTY. Mark Griffin, KB3Z
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
