My amp has shipped and will be here in a week. I have a question for
those of you using the KPA500 AUX connection with the FT-950 linear
interface connection on the rear panel.
The KPA500 manual I downloaded says pin 8 (TX INH) and pin 3 (GND) from
the FT-950 must be connected together then connected to pin 5 on the
KPA500 AUX connector. I looked at the FT-950 schematic and it appears
pin 8 can be left floating.
Also, have you had any issues with band selection using the FT-950
linear interface connection?
I realize the KPA500 has RF sensing for band selection, but I would like
to take advantage of the linear port available on the Yaesu.
Joe Hutchens ( AJ8MH )
http://webpages.charter.net/aj8mh-radio/______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html