I did some more troubleshooting. The receive antenna switches in and out as
it should. Basically it seems that 160 is completely dead.
Besides switching in additional capacitance and inductance on the BPF, what
else happens when the module is installed? Seems to me that is it.
Mike
AI4NS
_____
From: Mike Short [mailto:
[hidden email]]
Sent: Monday, February 26, 2007 2:39 PM
To: (
[hidden email])
Subject: 160M module
I have one in my K2, but there is no power out. Once upon a time it worked.
The only thing I have done to the K2 is install Tom's T/R Relay board. I was
getting a Hi Cur reading when requested power goes over about 1 W or so. Now
the power requested won't go over about .5W. The other bands work ok,
although 10M drops from 13W or so at the bottom of the band to about 9W at
the upper end. I just peaked the inductors again using Don's excerpt from
the K2 manual.
I am trading this, and would like to have 160M working.
Mike
AI4NS
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
