FW: FW: FW: power control (was kit arrived)

[Brett gazdzinski-2]

Can anyone describe how the power output control actually works?
I traced the circuit to the bank 1 part, I have no idea what bank 1 is.

The cpu seems to have some control over the power output, looking
at the output power sense circuit to display output power
on the bar graph and as a digital readout when in the tune mode.

You adjust the power control, but what is that actually doing,
changing the drive level to the PA by way of Q10, or something else?

Brett
N2DTS

>
> Brett,
>
> In TUNE, the power control loop is not as tight in the
> firmware portion
> of the loop as compared with normal keying.  The reason for
> that is to
> allow those using a manual tuner with their K2 to be able to
> adjust it
> without the power jumping quickly all over the place.

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

Brett,

The power output is totally controlled by the microprocessor.
The power knob (think of it as 'power requested') setting is known to
the microprocessor (full stop of thought here).

When the transmitter is tuned or keyed, the output is measured by the RF
  detector (or wattmeter if either the KPA100, KAT2 or KAT100 are
installed).  That power output level is scaled and sent back to the
microprocessor on the VRFDET line.  The microprocesor then compares the
actual power output with the requested power and changes the VPWR from
control board U8 as a response.  The VPWR signal is fed through the
keying waveshape and ALC ciruit (Control board U10A and Q8) which
produces the VALC voltage which is then fed to the drain of RF Board Q24
to control the amount of BFO injection into the Transmit Mixer.

The /BANK1 signals on the front panel are the scanning lines that tell
the microprocessor what the state of the buttons and controls are -
there is no direct control done on the front panel (except that the RF
Gain and AF Gain controls are fully analog and not microprocessor
controlled).

73,
Don W3FPR

Brett gazdzinski wrote:

> Can anyone describe how the power output control actually works?
> I traced the circuit to the bank 1 part, I have no idea what bank 1 is.
>
> The cpu seems to have some control over the power output, looking
> at the output power sense circuit to display output power
> on the bar graph and as a digital readout when in the tune mode.
>
> You adjust the power control, but what is that actually doing,
> changing the drive level to the PA by way of Q10, or something else?
>
> Brett
> N2DTS

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com