I've seen a lot of assistance for this thread that starts out with:
"The best way to proceed with an uncompleted project is to first check that
all components have been inserted in the correct location. Open the manual
to the parts listing and check each installed part for the correct value."
or some such wisdom. That is an EXCELLENT second step. The FIRST step, is go
to the web, download the manual in PDF format (so you can search on it) and
get the latest errata.
So the FIRST STEP is to HAND-WRITE THE ERRATA INTO THE MANUAL ITSELF IN
PLACE, and then proceed with "check that all components have been inserted
in the correct location".
Wouldn't you feel silly removing the "wrong" part because of the manual,
only to find in troubleshooting that the part had been replaced (or even
removed - C180 on the RF board is no longer used) in a note you didn't have!
hth
Dan / WG4S / K2 #2456
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
