Hi,
I want to realize a 144 contest setup with 2 PA, 2 antennas and 2
transverters tuned on the same frequency with therefore a unique K3
switched back and forth only during receive.
To do so, I want to feed two XV144 transverters in parallel at 28 MHz
from the KXV3 TX path interface (dual port interface) (For receiving, I
switch back and forth between the two transverters RX path). In the TX
path, I intend to use a BNC-Tee with the common port attached to the 28
MHz KVV3 port and the each transverter connected to the other Tee-Ports.
Is this OK or do I need a Wilkinson divider to feed each transverter
with the assumed 50 ohm resistance ? I didn't find any impedance figure
to be seen from the KXV3 nor from the XV144.
Tu for helping me with advice.
Luc F6HJO/HB9ABB
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
