I had not updated the firmware on my K3 in a while, so I went to the Elecraft site, downloaded the new K3 utility, found the new firmware, and proceeded to download it to the K3. I have suddenly lost the 100 w amp in the K3, and I can no longer link the two vfo's. I'm not sure what else is screwed up. Can anyone help?
73, Dick WO1I K3 911.
P.S. I did check the config and KPA3 is set to PA NOR.
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
