Firmware upload to K3 using Microham MK2

[John Gaynard]

It has been a while since I updated using my own laptop.  Can I use the Microham MK2 interface with the “No radio mode, and router query disabled, and 38400bps settings?  I just loaded the new K3 Utility so the utility software is current.  The last time I updated from this laptop, the FP flash memory did not exist.  I thought there was initially an issue with using the MK2 to update but that may have been resolved in the intervening timeframe.

 

John K8WDN

K3 #157

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Dick Dievendorff]

Possibly.  Give it a try.  But if you have difficulty with the firmware load, be prepared to cable the K3 directly to the PC.

 

Dick, K6KR

 

 

 

 

From: [hidden email] [mailto:[hidden email]] On Behalf Of John Gaynard
Sent: Thursday, December 11, 2008 6:06 PM
To: [hidden email]
Subject: [Elecraft] Firmware upload to K3 using Microham MK2

 

It has been a while since I updated using my own laptop.  Can I use the Microham MK2 interface with the “No radio mode, and router query disabled, and 38400bps settings?  I just loaded the new K3 Utility so the utility software is current.  The last time I updated from this laptop, the FP flash memory did not exist.  I thought there was initially an issue with using the MK2 to update but that may have been resolved in the intervening timeframe.

 

John K8WDN

K3 #157

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com