> From: Don Nesbitt <
[hidden email]>
> Subject: Re: [Elecraft] P3 Cursor Position Incorrect After Band change...
> To: "Phil Hystad" <
[hidden email]>
> Date: Thursday, September 2, 2010, 6:58 PM
> Hi Phil - I've been noticing it for a
> while but have just been too busy to comment. I first
> noticed it because the little "U" (bandwidth on CW) didn't
> center on the vertical indicator. Just using the mode switch
> to switch to "ALT" and back seems to cure it and it aligns
> where it should. -- Don N4HH
>
> --- On Thu, 9/2/10, Phil Hystad <
[hidden email]>
> wrote:
>
> > From: Phil Hystad <
[hidden email]>
> > Subject: [Elecraft] P3 Cursor Position Incorrect After
> Band change...
> > To: "Elecraft Reflector" <
[hidden email]>
> > Date: Thursday, September 2, 2010, 6:48 PM
> > On my P3, I notice that the little
> > cyan cursor location does not align itself properly
> during a
> > band change that also involves a mode change. For
> > example, switching from 17 Meter band with USB to 20
> Meter
> > band with CW leaves the cursor aligned to the right of
> the
> > center position as it would be for USB but not as it
> should
> > be for the CW signal. All IF shift controls are in
> > their normal position. Indeed, a power off and
> power
> > on cycle of the P3 resets the cursor location to be
> > correct.
> >
> > I figure if a power-off/power-on fixes a problem then
> there
> > probably is a problem.
> >
> > Anyone else seen this same thing? If it is unique
> to
> > my P3 maybe I have a very special P3 that might be
> worth a
> > lot of money (sort of like an old stamp with a flaw in
> it).
> >
> > 73, phil, K7PEH
> > K3 #3799, P3 #0030
> >
> >
> >
> ______________________________________________________________
> > Elecraft mailing list
> > Home:
http://mailman.qth.net/mailman/listinfo/elecraft> > Help:
http://mailman.qth.net/mmfaq.htm> > Post: mailto:
[hidden email]
> >
> > This list hosted by:
http://www.qsl.net> > Please help support this email list:
http://www.qsl.net/donate.html> >
>
>
>
>
Locked
