Here is some useful info if you should see ERR TXF show up after you
download 1.48/1.45.
----- Original Message -----
From: "Gary Surrency" <
[hidden email]>
To: "Gary Bartlett VE1RGB" <
[hidden email]>
Sent: Thursday, December 13, 2007 9:33 PM
Subject: VE1RGB Re: Lost TX with latest FW!!!
> Hi Gary,
>
> Just go back into the filter menus and be sure everything is set to the
> correct filter. See pages 43-44. The last f/w upgrade set defaults for the
> filters which may not agree with how you have installed the filters in
> your K3.
>
> Be sure and do all modes for FLTX to a filter such as 2.7 or 2.8kHz -
> whichever one your K3 has.
>
> You might want to redo the TX gain calibration again too, on pages 46- 47
> of the K3 Owner's manual.
>
> If not done, also do the REF CAL setup, using Method #2 as Method #3 is
> not implement yet if you have the 1ppm TXCO.
>
> Hope this gets it going! :-)
>
> --
> 73, Gary AB7MY
> =========
>
[hidden email]
> Elecraft Technical Support
>
> Gary Bartlett VE1RGB wrote:
>> I have just downloaded 1.48/1.45 and every attempt to transmit CW on any
>> band leads to ERR TXF. >>
>> Help!!
>>
>> Gary, VE1RGB
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
