On Sun, May 19, 2013 at 9:21 PM, James C. Hall, MD <
[hidden email]> wrote:
>
>
> Sent from my iPad
>
> Begin forwarded message:
>
>> From: "James C. Hall, MD" <
[hidden email]>
>> Date: May 19, 2013, 11:20:00 PM CDT
>> To: "
[hidden email]" <
[hidden email]>
>> Subject: Band decoding with TXBPF's
>>
>> Hello:
>>
>> For Field Day I'm planning on using the AUX I/O band data pins to feed the built-in band decoder of the TXBPF's I built a couple years ago. I won't be using the output of this decoder for antenna switching - just band following with the BPF's. I'll be utilizing an older Microkeyer for digital operations and this uses the AUX I/O for FSK and PTT.
>>
>> Looking back in the archives, I presume I will need a DB15 Y-cable which I see Elecraft sells and I presume ABCD on the TXBPF 5-pin DIN is the same as 0123 on the AUX I/O DB-15. I just need to make up this interface cable.
>> One other thing - my K3 is serial number 616, so I have the KIO3 board without the pull up resistors. This is more specific to the TXBPF, but does this unit need those resistors; that is, do I need the upgraded KIO3 board ?
Which TXBPFs? If it's the 5B4AGN kit, the schematic for his
band-decoder shows 10k pullups on the band data inputs, so you should
be fine.
I recently acquired an already-built 5B4AGN unit, but haven't gotten
around to interfacing it to my K3 yet.
73,
~iain / N6ML
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
