____________________________________
I've purchased knobs for my K2, K3, and KX3 from _www.73cnc.com_
(
http://www.73cnc.com/) .
They even modified a K2 knob to fit my K3 VFO B shaft. Much better than
the smaller VFO B knob!
And all my knobs have the ball bearing spinner dimples.
No connection with the company, just a happy camper.
Mike AC6JA
In a message dated 4/17/2014 2:07:35 P.M. Pacific Daylight Time,
[hidden email] writes:
For those owners of newer K2s, be aware that the NEW K2 encoder (those
with a board soldered to the back of the encoder) has a larger shaft
diameter than the older K2 encoders.
I mention this as a way of warning newer K2 owners that the normal "K2"
knob may not fit your K2.
The new encoder shaft diameter is the same as the K3 encoders, but the
K3 VFO A knob is too large for the K2 and the K3 VFO B knob may be too
small in diameter.
Know what you have in your K2 before ordering a replacement knob.
73,
Don W3FPR
On 4/17/2014 4:53 PM, Dick, K2ZR wrote:
> Review the link:
http://www.73cnc.com/product_p/k2blkmain.htm> These folks make a great weighted knob for the K2. You can often pick it
up
> at hamfest where they are in the flea market. They generally offer a show
> special for less. My guess is they will be at Dayton since trhey are
located
> in Ohio.
> I've been a happy user.
> 73,
> Dick, K2ZR/4
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
