Fwd: Re: KPA100 CAL tPA

[Lutz Pflughaupt]

Many thanks, I was confused but now it works fine.
73 de Lutz (DL7AVC)

----------  Forwarded Message  ----------

Subject: Re: [Elecraft] KPA100 CAL tPA
Date: Sunday 31 October 2004 15:47
From: [hidden email]
To: Lutz Pflughaupt <[hidden email]>

Remember you must press the edit key to move the edit line under the temp and
 then press the edit key then you can change the temp with the vfo knob then
 press the menu key two times to return to the normal display. 73
Jim Younce K4ZM
-------------- Original message --------------

> Hi Folks,
> my problem:
> After finishing all adjustments and calibration (also CAL tPA) without any
> problems, I wat to recheck the CAL tPA. Now on my display only " tPA 0C"
> shown. Is not possible to change temperature by VFO-knob.
> Many thanks Lutz (DL7AVC)
> _______________________________________________
> Elecraft mailing list
> Post to: [hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com

-------------------------------------------------------



_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com