Hi Im using an iMac and K3s with WSJT-x, Maclogger and JT bridge.
I have set the ALC high and Low and with the recommended 3 with 4th flashing.
Mic gain is line 19 and Line out in config 7 volume on Mac about 50% I have also tried high volume low mic gain and low volume and high mic gain.
Levels set with tune button on WSJT-x
Cat testing from within WSJT-X appears ok and test works fine.
8 data bits, one stop bit, no handshake, ppt on cat, mode Data/Pkt
Split opp none
Test cat green when pushed and test put put pushes the rig to transmit
Decodes no problem.
When I transmit the radio will transmit for the first pass or two / or tune then on the next will go into transmit then emits a bipp noise and shows a spike of power then stops sending out a signal and the when it goes back to receive no signal is seen in the programme I can still hear signal coming in.
I swapped to my Mac Book Air and that seems to work ok even if I put the power up.
I have disconnected every thing but the radio from the computer and am using a blue tooth mouse I have 4 wound chokes on the usb and this is the cable which worked perfectly well on the Mac Book air
This is starting to drive me nuts
HELP
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
