Heil Proset Plus

[Barry Simpson]

I have been following this thread for a while  and think that the initial
question was how to use the Proset Plus with the dual element, one of which
is the ic element designed for the Icom rigs.

 

I am not sure how this could be done without a special adapter but someone
might have practical  experience of the issue.

 

As regards the Elecraft Proset does this have a foam windshield on the
microphone ?

 

Barry Simpson  VK2BJ  K3 maybe July or August !!

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-4]

Barry,

I am not aware that Heil produced a Proset with an iC element in
combination with a non-iC element.  That combination just does not make
sense to me.  I do know that it is not a standard Heil product.

The combination of the Heil HC4 and HC5 elements is present in many of
the Heil microphones, bu not the combination of either the HC4 or HC5
along with the iC element.  Someone is confused (maybe me???).

73,
Don W3FPR

Barry Simpson wrote:
> I have been following this thread for a while  and think that the initial
> question was how to use the Proset Plus with the dual element, one of which
> is the ic element designed for the Icom rigs.
>  
>
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Geoffrey Downs-2]

I have been using a Heil Proset Plus (with HC4 and HC5 dynamic elements,
switchable) for a number of years, first with an FT1000MP Field and now with
K3 Ser. No. 266 built in January. It has always worked well for me. It plugs
into the 3.5mm (1/8") jacks on the rear panel of the K3 without the need for
an adapter. Of course bias is switched off. I took a tip from an earlier
posting on here and programmed a front panel button to switch between
Speakers + Phones and just Phones. To my ears the tx audio from the K3 is
better - cleaner and clearer - than from the Yaesu.

73 to all

Geoff
G3UCK

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com