Heil Traveler Headset w/K2??

[Steve_wGØAT]

Can anyone tell me if I have the correct Jumper Block configuration on  
the K2 for my Heil Traveler Headset? (Not the ProHeadset but the  
Traveler)  I'm using a Kenwood 8-pin adapter cable HSTA-K8 for the  
headset. So far everything seems to be working FB except for the audio?

I followed the Kenwood setup (2nd table) on P18 of KSB2 SSB adapter  
manual.
jumper block setup as follows:
AF -    1  JUMPERED
PTT - 2  JUMPERED
DN -  3  JUMPERED
UP -   4  JUMPERED
Func- NC JUMPER REMOVED
5V  -  ?   JUMPER REMOVED
GND - 7 JUMPERED
GND -8  JUMPERED

Results are no mic audio? Suggestions (besides tossing out the headset  
please!)

Tks Steve
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Steve_wGØAT]

It's WORKING!  Woohoo!

And the winning formula is:

All the jumpers are plugged in on the K2 jumper block EXCEPT #5 and  
the 10K bias resistor is wired between pins 1 & 6 on the back of the  
mic jack. Bingo! We have audio from the Heil Traveler to the K2!

Thanks to all for the last minute resolution and help! It was a puzzle  
I wasn't sure I was going to solve?!
After removing the front panel plus knobs more than 10-times I only  
wish I knew about Gary's IMAs before hand! Oh well I like to do things  
the hard way. Plus I learn a lot! Doh.

And Don in case you're wondering it's Rooster who carries the heavy  
loads and expendable items like the mic, tent, water and food. Peanut  
carries the K2 and other valuables. Reason is Rooster tends to bash  
his way through the undergrowth like a bulldozer thus I call him my  
QRO goat. Peanut thinks about where he's going and finds his way  
around with skill and finesse thus he's the QRP goat. And thus his  
load is less likely to get beat up!

Cheers, Steve
On Apr 3, 2010, at 2:26 AM, Gary Hvizdak wrote:

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html